Method 261.21
Web18 mei 2024 · Part 261: Identification and Listing of HW (amended 05/18/21, effective 6/30/21) Part 261 Appendices I-IV and Appendix IX (amended 11/15/22, effective 01/30/23) Part 261 Appendix VII (amended 02/21/17, effective 04/14/17) Part 261 Appendix VIII (amended 02/20/18, effective 04/14/18)
Method 261.21
Did you know?
Web(1) It is a liquid, other than a solution containing less than 24 percent alcohol by volume and at least 50 percent water by weight, that has a flash point less than 60 °C (140 °F), as determined by using one of the following ASTM standards: ASTM D93-79, D93-80, D3278-78, D8174-18, or D8175-18 as specified in SW-846 Test Methods 1010B or 1020C … WebApproved March 15, 2024, IBR approved for § 261.21 (a). ( 10) ASTM E168–88, “Standard Practices for General Techniques of Infrared Quantitative Analysis,” IBR approved for § 264.1063. ( 11) ASTM E169–87, “Standard Practices for General Techniques of Ultraviolet-Visible Quantitative Analysis,” IBR approved for § 264.1063.
Web(i) It exhibits any of the characteristics of hazardous waste identified in subpart C of this part. However, any mixture of a waste from the extraction, beneficiation, and processing of … Webof method-defined parameters, are intended to be guidance methods which contain general information on how to perform an analytical procedure or technique which a laboratory …
WebThe method of sampling and test procedure shall be the ASTM E 681-85 (incorporated by reference, see § 260.11 of this subchapter), or other equivalent methods approved by … Web2 apr. 2024 · The Methods Innovation Rule, which was finalized on June 14, 2005, revised 40 CFR 260.11 to remove the incorporation by reference of all SW-846 methods except …
Websubchapter a - general (parts 1 - 30-31) subchapter b - grants and other federal assistance (parts 33 - 49) subchapter c - air programs (parts 50 - 99)
Web261.21 Characteristic of ignitability. § 261.21 Characteristic of ignitability. (a) A solid waste exhibits the characteristic of ignitability if a representative sample of the waste has any of … thurayyah islam mediaWebNR 261.21 Compliance dates. Discharge of pollutants from facilities subject to the provisions of this subchapter may not exceed as appropriate: (1) By February 15, 1986 for pretreatment standards for existing sources (PSES); (2) At the commencement of discharge for pretreatment standards for new sources (PSNS). History: Cr. thurayur panchayathWeb( i) The term “compressed gas” shall designate any material or mixture having in the container an absolute pressure exceeding 40 p.s.i. at 70 °F or, regardless of the pressure at 70 °F, having an absolute pressure exceeding 104 p.s.i. at 130 °F; or any liquid flammable material having a vapor pressure exceeding 40 p.s.i. absolute at 100 °F as … thurayyah mitchellWeb11 feb. 2012 · How 40 CFR 261.21 (a) (1) reads: “It is a liquid, other than an aqueous solution containing less than 24 percent alcohol by volume and has a flash point less than 60˚C (140˚F)…” It goes on to reference the two … thurbarn road se6Web1.4 This method is restricted to use by, or under supervision of, appropriately experienced and trained personnel. Each analyst must demonstrate the ability to generate acceptable results with this method. 2.0 SUMMARY OF METHOD In a preliminary test, the test material is formed into an unbroken strip or powder train, 250 mm in length. thurayyah mitchell photoWebPart 261 Part 261 - Identification And Listing Of Hazardous Waste PART 261 - IDENTIFICATION AND LISTING OF HAZARDOUS WASTE Authority: 42 U.S.C. 6905, 6912 (a), 6921, 6922, 6924 (y) and 6938. Source: 45 FR 33119, May 19, 1980, unless otherwise noted. Authority: 42 U.S.C. 6905, 6912 (a), 6921, 6922, 6924 (y) and 6938. thurbbleWeb7 aug. 2024 · 1.2 Procedure A is applicable to distillate fuels (diesel, biodiesel blends, kerosine, heating oil, turbine fuels), new and in-use lubricating oils, and other homogeneous petroleum liquids not included in the scope of Procedure B or Procedure C. thurbarn road se6 images